PVA LIQUID 4L
Click Picture for more Info
PVA should be used to aid in the release of parts from a mold. It should be applied in three thin mist coats over...
Polyvinyl alcohol (PVA) is often utilized as a mold release agent in industries such as plastics, rubber, and composites. Here's how it works:
- Coating: PVA can be applied as a thin film or coating onto the surface of a mold or other surface where sticking might occur.
- Barrier: Once applied, the PVA forms a barrier between the surface and the material being molded or worked with, preventing adhesion.
- Water Solubility: PVA is water-soluble, which means that after the molding process is complete, the PVA can be easily washed away with water, leaving behind the molded object.
- Smooth Finish: PVA can also contribute to a smoother surface finish on the molded object, as it helps in preventing imperfections caused by sticking.
It's important to note that while PVA can be effective as a release agent in certain applications, its performance depends on the specific materials, processes, and conditions involved. For other applications, different types of release agents might be more suitable. Always ensure to test the compatibility and effectiveness of any release agent in your specific use case before widespread application.
PVA should be used to aid in the release of parts from a mold. It should be applied in three thin mist coats over nonporous, waxed mold surfaces. After the final wax coat has dried, begin by spraying a light tack coat of PVA. Typically, within 5 minutes the final heavier coats can be added. The PVA dries to form a smooth, glassy film. After part release, the residual film can be removed with water. PVA can also be sprayed over any polyester repair to provide an airless tack-free cure. Size - 4L Part # 55426
Featured positive reviews:
This is good stuff. I spray the first two coats so light you can't see it coming out. 2 more coats a bit heavier with the last going on wet. 15 min between coats. The finish is smooth as glass. I use a touch up gun with 90 PSI. Do not cut the PVA. Use as is.
- Average rating:HONEY WAX RELEASE AGENT WAXCan$46.9255054
Click Picture for more Info
Compounded with the purest grade carnauba wax, plus special binders and spreading agents, Honey Waxx has been the leading choice in mould release agents for decades. - Preval Sprayer COMPLETECan$14.9965322
Click Picture for more Info
PREVAL SPRAYER COMPLETE: You can spray just about every liquid solution including GEL COAT with the Preval Spray gun. Great for spraying PVA on mould or Gel Coat repairs. - Average rating:PATTERN SEALER 946mLCan$29.3163522
Click Picture for more Info
The purpose of pattern sealer is to seal the porous surface of the pattern. - Average rating:G860-2.5 Gelcoat HVLP Spray GunCan$189.9965321
Click Picture for more Info
This full size professional grade HVLP gun comes complete with a 2.5mm stainless nozzle, 0.6 litre plastic cup and plastic material strainer. - Wedge 1 1/4 INCH X 4 INCHCan$3.9965120
Click Picture for more Info
These wedges are a must for removing parts from fibreglass composite moulds.